General information about the pyboard

Local filesystem and SD card

There is a small internal filesystem (a drive) on the pyboard, called /flash, which is stored within the microcontroller’s flash memory. If a micro SD card is inserted into the slot, it is available as /sd.

When the pyboard boots up, it needs to choose a filesystem to boot from. If there is no SD card, then it uses the internal filesystem /flash as the boot filesystem, otherwise, it uses the SD card /sd.

(Note that on older versions of the board, /flash is called 0:/ and /sd is called 1:/).

The boot filesystem is used for 2 things: it is the filesystem from which the and files are searched for, and it is the filesystem which is made available on your PC over the USB cable.

The filesystem will be available as a USB flash drive on your PC. You can save files to the drive, and edit and

Remember to eject (on Linux, unmount) the USB drive before you reset your pyboard.

Boot modes

If you power up normally, or press the reset button, the pyboard will boot into standard mode: the file will be executed first, then the USB will be configured, then will run.

You can override this boot sequence by holding down the user switch as the board is booting up. Hold down user switch and press reset, and then as you continue to hold the user switch, the LEDs will count in binary. When the LEDs have reached the mode you want, let go of the user switch, the LEDs for the selected mode will flash quickly, and the board will boot.

The modes are:

  1. Green LED only, standard boot: run then
  2. Orange LED only, safe boot: don’t run any scripts on boot-up.
  3. Green and orange LED together, filesystem reset: resets the flash filesystem to its factory state, then boots in safe mode.

If your filesystem becomes corrupt, boot into mode 3 to fix it. If resetting the filesystem while plugged into your compute doesn’t work, you can try doing the same procedure while the board is plugged into a USB charger, or other USB power supply without data connection.

Errors: flashing LEDs

There are currently 2 kinds of errors that you might see:

  1. If the red and green LEDs flash alternatively, then a Python script

    (eg has an error. Use the REPL to debug it.

  2. If all 4 LEDs cycle on and off slowly, then there was a hard fault. This cannot be recovered from and you need to do a hard reset.