class SPI – a Serial Peripheral Interface bus protocol (master side)¶
SPI is a synchronous serial protocol that is driven by a master. At the physical level, a bus consists of 3 lines: SCK, MOSI, MISO. Multiple devices can share the same bus. Each device should have a separate, 4th signal, SS (Slave Select), to select a particualr device on a bus with which communication takes place. Management of an SS signal should happen in user code (via machine.Pin class).
Constructors¶
-
class
machine.
SPI
(id, ...)¶ Construct an SPI object on the given bus,
id
. Values ofid
depend on a particular port and its hardware. Values 0, 1, etc. are commonly used to select hardware SPI block #0, #1, etc. Value -1 can be used for bitbanging (software) implementation of SPI (if supported by a port).With no additional parameters, the SPI object is created but not initialised (it has the settings from the last initialisation of the bus, if any). If extra arguments are given, the bus is initialised. See
init
for parameters of initialisation.
Methods¶
-
SPI.
init
(baudrate=1000000, *, polarity=0, phase=0, bits=8, firstbit=SPI.MSB, sck=None, mosi=None, miso=None, pins=(SCK, MOSI, MISO))¶ Initialise the SPI bus with the given parameters:
baudrate
is the SCK clock rate.polarity
can be 0 or 1, and is the level the idle clock line sits at.phase
can be 0 or 1 to sample data on the first or second clock edge respectively.bits
is the width in bits of each transfer. Only 8 is guaranteed to be supported by all hardware.firstbit
can beSPI.MSB
orSPI.LSB
.sck
,mosi
,miso
are pins (machine.Pin) objects to use for bus signals. For most hardware SPI blocks (as selected byid
parameter to the constructore), pins are fixed and cannot be changed. In some cases, hardware blocks allow 2-3 alternative pin sets for a hardware SPI block. Arbitrary pin assignments are possible only for a bitbanging SPI driver (id
= -1).pins
- WiPy port doesn’tsck
,mosi
,miso
arguments, and instead allows to
specify them as a tuple of
pins
paramter.
-
SPI.
deinit
()¶ Turn off the SPI bus.
-
SPI.
read
(nbytes, write=0x00)¶ Read a number of bytes specified by
nbytes
while continuously writing the single byte given bywrite
. Returns abytes
object with the data that was read.
-
SPI.
readinto
(buf, write=0x00)¶ Read into the buffer specified by
buf
while continuously writing the single byte given bywrite
. ReturnsNone
.Note: on WiPy this function returns the number of bytes read.
-
SPI.
write
(buf)¶ Write the bytes contained in
buf
. ReturnsNone
.Note: on WiPy this function returns the number of bytes written.
-
SPI.
write_readinto
(write_buf, read_buf)¶ Write the bytes from
write_buf
while reading intoread_buf
. The buffers can be the same or different, but both buffers must have the same length. ReturnsNone
.Note: on WiPy this function returns the number of bytes written.