General information about the pyboard¶
Local filesystem and SD card¶
There is a small internal filesystem (a drive) on the pyboard, called
which is stored within the microcontroller’s flash memory. If a micro SD card
is inserted into the slot, it is available as
When the pyboard boots up, it needs to choose a filesystem to boot from. If
there is no SD card, then it uses the internal filesystem
/flash as the boot
filesystem, otherwise, it uses the SD card
(Note that on older versions of the board,
/flash is called
The boot filesystem is used for 2 things: it is the filesystem from which
main.py files are searched for, and it is the filesystem
which is made available on your PC over the USB cable.
The filesystem will be available as a USB flash drive on your PC. You can
save files to the drive, and edit
Remember to eject (on Linux, unmount) the USB drive before you reset your pyboard.
If you power up normally, or press the reset button, the pyboard will boot
into standard mode: the
boot.py file will be executed first, then the
USB will be configured, then
main.py will run.
You can override this boot sequence by holding down the user switch as the board is booting up. Hold down user switch and press reset, and then as you continue to hold the user switch, the LEDs will count in binary. When the LEDs have reached the mode you want, let go of the user switch, the LEDs for the selected mode will flash quickly, and the board will boot.
The modes are:
- Green LED only, standard boot: run
- Orange LED only, safe boot: don’t run any scripts on boot-up.
- Green and orange LED together, filesystem reset: resets the flash filesystem to its factory state, then boots in safe mode.
If your filesystem becomes corrupt, boot into mode 3 to fix it. If resetting the filesystem while plugged into your compute doesn’t work, you can try doing the same procedure while the board is plugged into a USB charger, or other USB power supply without data connection.
Errors: flashing LEDs¶
There are currently 2 kinds of errors that you might see:
- If the red and green LEDs flash alternatively, then a Python script
main.py) has an error. Use the REPL to debug it.
If all 4 LEDs cycle on and off slowly, then there was a hard fault. This cannot be recovered from and you need to do a hard reset.