network — network configuration

This module provides network drivers and routing configuration. Network drivers for specific hardware are available within this module and are used to configure a hardware network interface. Configured interfaces are then available for use via the socket module.

For example:

# configure a specific network interface
# see below for examples of specific drivers
import network
nic = network.Driver(...)
print(nic.ifconfig())

# now use socket as usual
import socket
addr = socket.getaddrinfo('micropython.org', 80)[0][-1]
s = socket.socket()
s.connect(addr)
s.send(b'GET / HTTP/1.1\r\nHost: micropython.org\r\n\r\n')
data = s.recv(1000)
s.close()

class WLAN

This class provides a driver for WiFi network processor in the ESP8266. Example usage:

import network
# setup as a station
nic = network.WLAN()
nic.connect('your-ssid', 'your-password')
# now use socket as usual

Constructors

class network.WLAN

Create a WLAN driver object.

Methods

wlan.connect(ssid, password)

Connect to the specified wireless network, using the specified password.

wlan.disconnect()

Disconnect from the currently connected wireless network.

wlan.scan(cb)

Initiate scanning for the available wireless networks.

Scanning is only possible if the radio is in station or station+AP mode; if called while in AP only mode, an OSError exception will be raised.

Once the scanning is complete, the provided callback function cb will be called once for each network found, and passed a tuple with information about that network:

(ssid, bssid, channel, RSSI, authmode, hidden)

There are five values for authmode:

  • 0 – open
  • 1 – WEP
  • 2 – WPA-PSK
  • 3 – WPA2-PSK
  • 4 – WPA/WPA2-PSK

and two for hidden:

  • 0 – visible
  • 1 – hidden